- Country of manufactureRussia
Products: Promix - CR. RX.04 radio remote control controller with built - in power supply (12 V, 0.5 A)
Designed for remote control of an electromagnetic, electromechanical lock (latch) or other actuators by means of a Promix - CR. TX.01 remote key (supplied separately).
The built - in power supply (0.5 A) of the controller is used to power the actuator.
The controller is produced in three versions, differing in the type of load connection:
- main - four push terminal blocks, load wires are connected from above;
- 01 - two connectors on the side;
- 02 - four push terminal blocks, load wires are connected from the side.
Programming of the key fob into the controller and the time of the open state of the lock is carried out by the master key fob Promix - CR. TX.01 - M (supplied separately) when the controller is turned on, or by a jumper on the case.
Allows to control normally open (open without voltage) and normally closed (closed without voltage) locks.
- Controller supply voltage, V (50 Hz): 220 ± 20
- Power supply voltage of the executive device, V (direct current): 12 - 16
- Rated load current, A, no more: 0.5
- Built - in overload protection
- Operating frequency, MHz: 433.92
- Operating range with Promix - CR. TX.01 remote keyfob (with line of sight), m, not less: 30
- Sensitivity, μV: 7
- Memory capacity, remote keyfobs: 7
- Output key actuation time, s: 1 - 15
Overall and mounting dimensions of Promix - CR. RX.04
Photo of the controller Promix - CR. RX.04
Photo of the controller Promix - CR. RX.04 - 01
Photo of the controller Promix - CR. RX.04 - 02
- Electromechanical locks
- Card readers
- Display and voice announcement devices
- Power supplies and transformers
- Lock accessories