- Hardness and Wear Resistance
- Fatigue and Bend Strength
- Corrosion Properties
- Lubricity and Metal Flow
The stamping and forming industries have always been faced with costly downtime and expensive die repairs due to wear caused by metal flow. Now, there's a low temperature, environmentally non-hazardous alternative to plating processes, for even the largest of dies: Ionitriding®. All types of steel used for tooling in stamping and forming can be Ionitrided.
- forming dies
- draw dies
- draw rings
- progressive dies
- machinery components
- die sections
Design changes and repairs to damaged dies can be implemented and blended into die surface without mis-match problems.
Depending on the magnitude of the alloying elements and application, Sun Steel Treating can improve the hardness profile and depth of the treated layer...virtually distortion free.*
We use computer-driven processing and control techniques to monitor and maintain workpiece temperature, vessel pressure, power levels, gas composition, and cycle times. The result: A highly repeatable layer composition, case depth (.005-0.020"), hardness (60/65 RC and higher) and low coefficient of friction (.10 against steel) for your stamping and forming dies.
Larget vessel capacity is up to 72" H x 108" W x 180" L (183cm x 274cm x 457cm) and 60,000 lbs./load.
*Accurate, distortion-free processing requires information about material chemistry, machining practices, welding and heat treatment process. Tempering/stress relieving should be performed a minimum of 50°F above Ionitriding processing temperature.